Hoppe Swing Hook Shootbolt Gear - 1-3/4" (45mm) Backset, 1 Inch Throw, 24-7/16 Inch Hook

Hoppe Swing Hook Shootbolt Gear, 1-3/4" (45mm) Backset with 1 Inch Deadbolt Throw

This is the bottom gear of a Hoppe HLS9000 swing hook and shootbolt lock, which carries one swing hook and one shootbolt on the strip below the handle.

A swing hook and shootbolt lock works in two directions at once. The hooks rotate out sideways, catch behind keepers in the jamb and pull the panel in against the weatherseal. The shootbolts drive vertically into the head and the sill. Hoppe built the combination for wind load: the hooks stop the door being pushed off the jamb, the bolts stop it twisting out of square, and together they hold a tall panel flat against pressure that would defeat either on its own.

The complete strip is three pieces. The gear at the bottom carries one hook and one shootbolt. A middle extension carries the hooks above the handle. A top extension carries the shootbolt into the head. All three are ordered separately, and the middle extension is what sets the point count: the twin hook version makes the five point lock, the single hook version makes four.

Manual operation. Lifting the handle throws every hook and every shootbolt on the strip at once; the key throws the deadbolt separately.

Notes

• Backset: 1-3/4" (45mm), measured from the edge of the door panel to the center of the handle spindle
• Deadbolt throw: 1" (25mm)
• Handle height: 36" (914mm), measured from the bottom of the door to the center of the handle spindle
• Bottom swing hook position: 24-7/16" (620mm) below the handle
• Shootbolt throw: 25/32" (20mm) into the sill
• Faceplate: 5/8" (16mm) wide, stainless steel
• Locking points on this piece: one swing hook into the jamb plus one shootbolt into the sill
• Hoppe code: M/45/25 914 SW1SB1 620 16S 20
• Bottom gear, with its swing hook and its sill shootbolt. Middle and top extensions are ordered separately.
• No cutoff allowance is published for this gear. Match the handle height rather than planning to trim it.

Not sure which lock fits your door? Fill out our identification form or call us and we'll confirm the correct part.