Hoppe Key Operated Multipoint Lock - Standard Function, 73-85 Inch Door

Hoppe Key Operated Multipoint Lock, Standard Function

Special order, non-returnable. Allow three to four weeks to ship. Check the faceplate width and door height before you order.

There is no lever action on this lock. Two full turns of the key from outside, or the thumb turn from inside, drive the roundbolts and swinghooks into the frame and pull them back again. It is the lock used on doors carrying a pull handle rather than a lever, which leaves nothing to lift.

The 24mm faceplate is how you tell it apart from Hoppe's lever operated ranges, which run 16mm or 20mm. Measure the width of the steel strip on the edge of the door panel. The parts do not interchange between the two families.

This is the shorter of the two standard function lengths, for door panels from 73.62" to 85.43" (roughly a 6'8" door). For a taller panel use 40005781.

You will also need a 360 degree cylinder. The key has to turn twice, which an ordinary euro profile cylinder will not allow. Choose 11645556, 11645544 or 11645568 by the thickness of your door panel.

Notes

• Function: Standard. The key or thumb turn retracts the latch; an interior lever also retracts the latch
• Faceplate: 15/16" (24mm) wide, stainless steel
• Backset: 1-3/4" (45mm), from the edge of the door panel to the center of the handle spindle
• Handle height: 40.2" (1020mm)
• Handle shaft: 5/16" (8mm)
• Locking points: roundbolt and swinghook, plus a spring latch
• Top locking point: 29-1/4" (743mm). Bottom locking point: 30-1/4" (768.5mm)
• Overall length: 85.43" (2170mm)
• Door height range: 73.62" - 85.43" (1870 - 2170mm)
• Not handed. The latch and deadbolt strike is handed and is a separate part
• Requires a 360 degree key cylinder, ordered separately
• Special order, non-returnable. Allow three to four weeks

Not sure which part fits your door? Fill out our identification form or call us and we'll confirm the correct part.